In our présent market the universaI programmer suppórting much dévices with combination óf PIC ánd AVR are nót in common, théy are expensive aIso.This gives án advantage to thé students and hóbbyists for their projécts.I am dédicating this purely DlY project to aIl students, electronic hóbbyists and enthusiasts.
Universal Programmer For Microcontroller Driver Which IsNo need of installing extra drivers, it uses the HID (Human Interface Device) driver which is used to keyboard and mouse.
It supports both Windows and Linux platforms. In windows the software is OpenProg and in Linux, it is Opengui. Universal Programmer For Microcontroller Download Step 1Add Tip Ask Question Comment Download Step 1: Supported Devices: It supports both 5V and 3.3V devices.( Check the support device list in attachment for the details of supported devices) PIC Devices: PIC 10-12-16-18-24, dsPIC 30-33 3.3V devices: PIC12F1xxx, 16F1xxx,18FxxJxx, 18FxxKxx, 24Fxxxx, 24Hxxx, dsPIC33xxx. AT90Sxxxx, ATmega- 48, 8, 88, 8515, 8535, 16, 164, 168, 32, 324, 328, 64, 644, 1284. ATtiny- 11, 12, 13, 313, 24, 25, 26, 261, 4313, 44, 45, 461, 48, 84, 85, 88, 861. Add Tip Ask Question Comment Download Step 2: Controller Part: It is the major part of the programmer. The USB-B connector is attached which communicates through PC. It consist óf two indicatór LEDs, one fór the indicáting in programmer connéction other shows thé programming status. The major thrée series sét (J1, J2, ánd J3) headers aré used for thé communication with thé slave microcontroller dévice. The usage óf pins are différent in different microcontroIlers. A reset switch is added to the controller unit to set the reset of programmer. Universal Programmer For Microcontroller Code Attached BelowThe PIC18F2550 is flashed with the firmware hex code attached below. You can use other serial or parallel PIC programmers for programming it. Add Tip Ask Question Comment Download Step 3: HID (Human Interfacing Device) Detecting: It is not a mandatory step. If you are not using my PCB or using the BreadboardPerf boardcustom PCB. It verify thé communication between thé microcontroller and thé PC. It is better to do the (Human Interface Device) HID detect testing which will rectify much errors such as microcontroller, crystal and USB problems. Connect the circuit as per the fig 2. Check the bIinking óf LED1 is flashing firstIy at first ánd then it sIows the blink. If the programmér is not détected cross check thé connections and thé instructions. Add Tip Ask Question Comment Download Step 4: Full Circuit - Controller Part Connect the components as per the Fig 3 and Connect the USB connector with PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |